Fagor Dro NV-300T Installation Manual page 16

To end editing a parameter, follow one of these steps:
. Press
ENTER
. Press
C
. Press the other axis key (if it is an axis parameter) to save the display
value and go on to the editing it for the other axis selected.
To modify a parameter, press
to the previous one. Then, select the axis affecting this parameter.
To quit the parameter editing mode:
Press
C
To recover the factory set for the installation parameters:
While displaying parameter PAR00, press:
NV-300T/301T Man: 9910 Soft: 2.xx
, to save the displayed value.
to cancel the change and recover the previous value or---
ENTER
to go on to the next one or
Installation Manual - Page: 15
1
to return
2