Table of Contents
Advertisement
PAR11
Miscellaneous, binary.
Digit
8, 7, 6, 5, 4, 3, 2
1
PAR12
To set the negative axis travel limit.
Possible values: between -99999.999 and 0.
When the axis exceeds this distance, the corresponding axis display
starts blinking until it is moved back into the work zone.
This value will be in mm or inches depending on whether the INCH
LED is off or on.
PAR13
To set the positive axis travel limit.
Possible values: between 0 and 99999.999
When the axis exceeds this distance, the corresponding axis display
starts blinking until it is moved back into the work zone.
This value will be in mm or inches depending on whether the INCH
LED is off or on.
PAR 14 To carry out the home search when the feedback device does NOT
have reference marks "Io" (for example, FAGOR MKT scales), this
parameter must be set to "1".
This way it is possible to preset a home value in Machine Reference
mode. Factory setting = "0".
NV-300T/301T Man: 9910 Soft: 2.xx
Not being used. Must be set to "0".
The
key affects one axis ( = 0) or both ( = 1).
If it affects by axis, after pressing
key.
It may toggle from absolute reading mode to incremental. This
parameter determines whether this toggle affects one axis or
both.
Factory setting: "1"
one must press the axis
Installation Manual - Page: 19
Hide quick links:
Advertisement
Table of Contents
