Table of Contents
Advertisement
For example: If a counting resolution of 0.005 mm was selected (taking into
Radius / Diameter:
With this model, one can display twice the real displacement of the X axis
(diameter) by pressing
the double or real counting mode respectively.
"Z" axis as a single axis or a combination of two (Z
To display the Z axis position, one or two feedback devices may be used. One
for the carriage (Z
When using two feedback devices, the "Z" axis display may show the position
of Z
, that of Z
1
axes.
To do this, use the
the 3rd display will show a "1" for Z
that the displayed "Z" axis value corresponds to the combined position of "Z
+ Z
".
2
2.2
INCREMENTAL, ABSOLUTE AND WITH RESPECT TO
MACHINE REFERENCE ZERO
This DRO displays the present coordinate of two (XZ) or three axes (X, Z
Z
and Z
+Z
2
1
2
Coordinate means the distance from one point or position with respect to
another chosen as reference.
This DRO can display the position of the axes in incremental or absolute mode
or referring to home.
The lower figure displays the coordinates of an axis which would appear in
the different modes:
NV-300T/301T Man: 9910 Soft: 2.xx
account the type of scale etc.) by the installation parameter
PAR01, it could occur that it is enough for the operator to
display every 0.010 mm (0.020, 0.030, etc.) so that the right-
hand digit is not required (0.01, 0.02, 0.03, etc.).
. Led Φ of the X axis will go on or off to indicate
1
2
) and the other one for the compound (Z
1
or the result from combining (adding) the positions of both
2
key and every time it is pressed, the rightmost digit of
)
, a "2" for Z
or it will turn off to indicate
1
2
Operation Manual - Page: 7
and Z
):
1
2
).
2
1
,
1
Hide quick links:
Advertisement
Table of Contents
