Fagor Dro NV-300T Installation Manual page 32

- In Incremental (I), when the ABS and
the present position of the axis to the previous position is displayed.
Note: On this model, the incremental reading is linked to the absolute so
when presetting a new part zero, the incremental zero will also
change maintaining the previous distance relative to the part zero.
- In Absolute (ABS), when the ABS led is on and the
from the present position of the axis to part zero (0) is displayed.
- In reference zero (
position of the axis to home (Io) chosen in the feedback system (scale or
encoder) is displayed. To access this mode use
To change from one of these display modes to another, press
relevant led goes on or off as described above.
It could occur that the installation parameter PAR11(1) has been set to "0"
for key to independently affect each axis so that one axis can display its
position in incremental mode while the other does this in absolute. In this case,
to change the display mode for a particular axis, press sequence:
"X" and
for "Z".
Page: 8 - Operation Manual
), when led is on, the distance from the present
leds are off the distance from
is off, the distance
key.
NV-300T/301T Man: 9910 Soft: 2.xx
until the
for