Fagor Dro NV-300T Installation Manual page 19

PAR08 Indicates whether the alarms for feedrate, travel limits and feedback
will be activated or not.
Digit
8, 7, 6 Not being used at this time. Must be set to "0".
5 Detect feedback signal weakness on NVxx1 models.
4 Value for the feedback alarm contact (0=low, 1=high)
3 Detect feedback alarm provided by the scale.
2 Detect travel limits (PAR12 and PAR13).
1 Detect feedback speed alarma.
Possible values: 0 (alarms off) and "1" (alarms on).
Factory values: 0
The feedback (. . . . . . .) and travel limit overrun alarms (axis display
blinking) will be displayed if the corresponding bit of
PAR08 = "1".
The blinking axis error is cleared by returning the axis within its
limits
The speed alarm is cleared by pressing
PAR09 Axis sag compensation. Independent for each axis.
Numeric value within ±99.999 millimeters per meter.
Factory setting: 0.
Notes: Even when selecting the display in inches, this value
1 inch = 25.4 mm
PAR10 Offset of the reference point with respect to the reference zero of the
scale, independent for each axis.
Numeric value in resolution units for each axis.
Factory setting: 0.
This value will be in mm or inches depending on whether the INCH
LED is off or on.
Page: 18 - Installation Manual
MUST ALWAYS BE IN MILLIMETERS.
.
C
NV-300T/301T Man: 9910 Soft: 2.xx