1.2
REAR PANEL
Dimensions of the Built-in model:
On the back of the unit the following items may be found:
1.- Power switch. When the unit is turned off by this switch, the DRO no
longer reads axis position. Therefore, it is recommended to use the
at the front panel to turn the display off so the DRO continues keeping track
of the axes position when they are moved.
2.- Three-prong power connector for AC and ground connection.
3.- M6 mm terminal for general machine ground connection.
Some of the following connectors might not be available depending on
specific models:
Page: 10 - Installation Manual
NV-300T/301T Man: 9910 Soft: 2.xx
key