Table of Contents
Advertisement
3.
PARAMETER SETTING
This DRO has a number of installation parameters to configure it for a
particular application.
The format for these parameters depends on whether they are general or
particular for each axis.
.
If it affects the axes, the parameter number (PAR??) appears at each axis
and the corresponding axis key must be pressed to modify it.
.
If it is a general parameter and there are more than one axis, the X display
will show the parameter number and the Z its current value; if there is only
one axis, its number will appear on the X display and, after pressing
its value.
There are several kinds of parameters depending on how to set them:
·
With binary values. The value of each digit toggles between "0" and "1"
when pressing its corresponding key from
to the rightmost digit and
·
Numeric values, usually with the corresponding axis resolution, they are
entered as regular preset.
·
Options, the value is changed by pressing
options appear in a cyclic way.
To edit a parameter, the DRO displays must be on. Then press
The X axis display shows the word "COdE". Then key in: 060496
Then, select the axis affected by this parameter.
Once in regular display mode, parameter PAR05 (scaling factor) may also
be recalled by pressing
without having to go through all the parameters previous to the desired
one.
To go directly to a particular parameter
previous ones, (once in parameter editing mode) press:
Page: 14 - Installation Manual
to the leftmost one.
+
, so the work mode may be changed
C
NV-300T/301T Man: 9910 Soft: 2.xx
to
where
which will make the various
-
without going through the
[parameter Nr.]
,
corresponds
.
ON
C
OFF
.
ENTER
Hide quick links:
Advertisement
Table of Contents
