Table of Contents
Advertisement
44
INSPECTION AND MAINTENANCE
ENOM01306-0
2. Periodic Inspection
It is important to inspect and maintain your outboard motor regularly. At each interval
on the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or num-
ber of months, whichever comes first.
Item
Carburetor *1
Fuel filter
Fuel System
Piping/Hose
Fuel tank
Ignition
Spark plugs
Starting
Starter rope
System
Propeller
Shear pin &
Split pin
Lower Unit
Gear oil
Water pump *1
10
Bolt and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
Servicing Interval
10 hours
50 hours
Every 100
or
or
hours or
1 month
3 months
6 months
Action
Clean, and adjust.
Check and clean or Replace.
Check and Replace.
Clean.
Check gaps. Remove carbon
deposits or Replace.
Check for wear or chafting.
Check for bent blades, damage,
wear.
Check and Replace.
Replace or Fill gear oil and check
for water leaks.
Check for wear or damage.
Retighten.
Apply and pump in grease.
Check for corrosion.
Check for corrosion and
deformation.
Remarks
0.9–1.0 mm
(0.035–0.039 in)
180 mL (6.1 fl.oz.)
: 3.5B2
90ml (3.0 fl.oz.) :
2.5A2/3.5A2
Advertisement
Table of Contents
