Starting The Engine - TOHATSU M2.5A2 Owner's Manual

26
ENGINE OPERATION
ENOM00045-D

2. Starting the engine

ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
Run the engine only at idling.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 47)
3
7
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-0
Be sure to stop engine immediately if cooling
water check port is not discharging water,
and check if cooling water intake is blocked.
Operating engine could lead to overheating
potentially leading to engine damage. Con-
sult an authorized dealer if the cause cannot
be found.
CAUTION
1
ENOF00863-0
CAUTION
ENOW00032-B
CAUTION
Do not try to crank after engine has started.
ENOW00941-0
CAUTION
When the shift lever is at the "NEUTRAL"
position, never move the throttle lever to
medium or high speeds. This may cause seri-
ous damage to the engine by rotating it at
excessively high speed. (3.5B2)
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1. Stop switch lock
ENON00924-0
Note
The engine will not start if the lock is in
released condition.
1
ENOF02014-0