Engine Operation; Before Starting; Fuel Feeding - TOHATSU M2.5A2 Owner's Manual

Hide thumbs Also See for M2.5A2:
Table of Contents

Advertisement

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-B
CAUTION
Be sure to fill the engine before star ting
engine. (To properly fill the engine with oil
follow the instructions. See page 21)
ENOM00044-F

1. Fuel feeding

ENOW00029-A
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
1. Before opening fuel tank cap, turn air
vent screw two turns counterclock-
wise to release air pressure in the fuel
tank.
1. Two turns the air vent screw
2. Fuel tank cap
2. Open the fuel cock.
ENOF01710-B
1. Fuel cock
ENOW00937-0
Be sure to close the fuel cock when the out-
board motor is tilted up Otherwise, fuel
could overflow.
ENON00923-0
Note
If fuel is not supplied immediately to the
carburetor (new engine or after cleaning),
wait for about 15 seconds for the proper
quantity of fuel to flow into the carburetor
after opening the fuel cock.
1
1
CAUTION
25
2
ENOF02007-0
7
ENOF02028-0

Advertisement

Table of Contents
loading

This manual is also suitable for:

M3.5a2M3.5b2

Table of Contents