Download Print this page

B-Tech System 2 BT7051 Manual

50mm (2 inch) large accessory collar with covers

Advertisement

Quick Links

BT7051
50MM (2 INCH) LARGE ACCESSORY COLLAR
WITH COVERS
• Heavy duty accessory collar for use with 50mm (2") poles
• Provides attachment for B-Tech modulus system mounts
• Double attachment
• Aesthetic cover plates included to hide fasteners
Head Office
B-Tech International Ltd.
Bennett House, Long March, Daventry, Northants NN11 4NR, UK
Tel: +44 (0)1327 300 787 Fax: +44 (0)1327 706 562
Email: info@btechavmounts.co.uk
Made in China
This pack contains:
1 heavy duty collar with covers
O 52
84
24
Europe
B-Tech PRO-AV bvba
Brixtonlaan 32, Zaventem 1930,Brussels, Belgium
Tel: +32 (0)2 720 92 71 Fax: +32 (0)2 725 42 15
Email: info@btechproav.com
www.btechavmounts.com
Copyright 2009.
©
This collar is intended for use only with the maximum
Caution:
Do not exceed the maximum weight limit indicated for this product.
weights indicated. Use with heavier than the maximum
Failure to comply may cause instability and possible serious injury.
indicated may result in instability causing possible injury.
Important Safety Instructions.
Read first
Do not attempt to install this product until all instructions and warnings have been read and
properly understood. Please keep these instructions for future reference.
B-Tech International Limited, its distributors and dealers are not liable or responsible for
damage or injury caused by improper installation, improper use or failure to observe these
safety instructions. In such cases, all guarantees will expire.
General
B-Tech International Ltd recommends that a professional AV installer or other suitably qualified
person install this product. Great care must always be taken during installation as most AV
equipment is of a fragile nature, possibly heavy and easily damaged if dropped.
If you do not fully understand the instructions or are not sure how to install this product safely,
then please consult a professional for advice and/or to install this product for you. Failure to
mount this product correctly may cause serious injury or death both during installation and at
any time thereafter.
Do not mount any AV equipment that exceeds the specific weight limit of the product you are
installing. This weight limit will be clearly stated on each product and its packaging and will
vary from product to product.
Product location
Please pay careful attention to where this product is located.
If located in a public or frequently populated area ensure that the product is out of the
immediate reach of people. If any AV equipment is to be suspended over the likely path or
location of people then great care should be taken to secure all parts of the installation from
falling.
Fixing hardware
It is highly recommended that all fixing screws be used where supplied and that the purpose of
all other fixing hardware is fully understood.
The installer must be satisfied that any supplied fixing hardware is suitable for each specific
installation. If any fixing screws or included hardware are deemed not sufficient for a safe
installation then please consult a professional or your local hardware store.
Hazard limitation
Some products have moving parts and the potential to cause injury through the crushing or
trapping of fingers or other body parts.
Particular attention to the nature of moving parts is required especially when assembling
installing and adjusting during set up.
Immediately after installations double-check that the work done is safe and secure. Double-
check all necessary fixings are present and are of ample tightness.
It is recommended that periodic inspections of the product and its fixing points are made as
frequently as possible to ensure that safety is maintained. If in doubt consult a professional AV
installer or other suitably qualified person.
North America
B-Tech Audio Video Mounts .
10 Greg Street, #108, Sparks, NV 89431, USA
Tel: (1)800 975 5812 Fax: (1)800 592 2876
Email: info@btechavmounts.com
v.0209 OR1BX
Asia Pacific
B-Tech International (Hong K ong) Ltd .
23rd Floor, Manulife Tower, North Point, HK
Tel: (+852) 2556 7337 Fax: (+852) 2556 7321
Email: info@btechavmounts.com.hk
PAGE 1 / 2

Advertisement

loading

Summary of Contents for B-Tech System 2 BT7051

  • Page 1 Do not attempt to install this product until all instructions and warnings have been read and properly understood. Please keep these instructions for future reference. B-Tech International Limited, its distributors and dealers are not liable or responsible for O 52 damage or injury caused by improper installation, improper use or failure to observe these safety instructions.
  • Page 2 v.0209 OR1BX PARTS LIST BT7051 PARTS LIST PART NAME DESCRIPTION BT7051 COLLAR TO FIT 50mm POLES M8 X 15mm GRUB SCREWS TO CLAMP COLLAR TO POLE Attention! M8 SPRING WASHER SITS UNDER SCREW HEADS Ensure safety bolt (Part 5) M8 X 12mm FLAT CROSS HEAD TO ATTACH ACCESSORIES is in place before any AV SCREW...