Landoll 5210 Operator's Manual page 39

d. If the display shows "Ent":
You must enter your password using the UP and
DOWN buttons. When your password is
displayed, press the FUNC button to test the
password. If the password is correct, you will be
able to change the acre counter settings. The
password will be viewable until the acre counter
powers down. When the acre counter is powered
up again, you will have to re-enter the password
to change settings (See Figure 4-14.)
If the password is not correct, you will not be able
to change the acre counter settings. When the
"PASS" function is selected again, "ENT" will
appear in the display.
e. Changing the password:
Select a new password using the UP and DOWN
buttons. Press the FUNC button until the word
"SEt" appears in the display. Release the FUNC
button. The number in the display is your new
pass code. Make sure you write it down! To
disable the password, try setting it to "0000".
Press and hold the FUNC button until the word
"dIS" appears in the display (See Figure 4-15.)
f. If the password is forgotten, it can be disabled by
removing the batteries. The password is
intended for rental units. It is recommended that
a seal be affixed to the rear plate of the acre
counter to determine if the settings have been
tampered with.
OPERATION AND MAINTENANCE
En
password prompt
Figure 4-14: Password Prompt
SE
password change prompt
Figure 4-15: Password Change Prompt
PASS
PASS
4-15