Electronic Control Features - Kenmore 596.53462302 Use & Care Manual

Dispenser features,

Electronic control features

DISPENSER
WATER
OPERATION
To dispense water:
➢ Select the WATER button.
➢ Press container against dispenser
pad.
To dispense ice:
➢ Select the CUBE button for
cubed ice.
➢ Press the CRUSH button for
crushed ice.
➢ Press container against dispenser
pad.
NOTE: If water dispenser is
continuously active for more than 2
minutes, an automatic lock out sensor
will shut down power to dispenser area.
For instructions on how to unlock your
dispenser, see the section entitled
Dispenser Lock below.
DISPENSER LOCK
This feature prevents ice or water
from being dispensed.
To lock and unlock dispenser:
➢ To lock dispenser, press and hold the
LOCK/UNLOCK button for 3
seconds. A green indicator light
above button confirms dispenser is
locked.
➢ To unlock dispenser, hold the
LOCK/UNLOCK button for 3
seconds. Green indicator light above
button will go out.
20
cont.
OFF
DISPLAY CONFIRM MAX
TEMP SET
FREEZE
ON/OFF SETTINGS
ON
DISPENSER
FILTER
LOCK
GOOD
WATER
UNLOCK
CHANGE
LIGHT FUNCTION
CRUSH
CUBE
The light function offers two
settings: OFF and AUTO.
The OFF setting will turn off the
WATER
dispenser cavity light.
The AUTO setting allows the SENSOR
to measure the surrounding light levels
and adjust the power of the cavity light
accordingly. When the sensor registers
CUBE
lower light levels (night time, darkened
kitchen), the cavity light will respond at
CRUSH
50% power. When the sensor registers
high light levels (lighted kitchen, direct
sunlight), the cavity light will not activate.
NOTE: Dispenser light will operate at
full power when ice or water functions
are in use.
To activate auto setting:
➢ Press the ON/OFF button located on
control panel. When the green
indicator light above the button
display is on, the cavity dispenser
light will use the AUTO setting.
LOCK
UNLOCK
To deactivate auto setting:
➢ Press the ON/OFF button located on
control panel. Green indicator light
above button will go out.
MAX
TEMP SET
COOL
LIGHT
CRUSH CUBE
ON/OFF
LIGHT
LIGHT
ON/OFF
SENSOR
VACATION ALARM
OFF
MODE
LIGHT
SENSOR
FILTER STATUS
INDICATOR
LIGHT
The filter status indicator light serves as
a reminder to replace the water filter. A
green light indicates that the filter is in
good condition. A red light indicates the
filter should be changed. Once light
turns red, it will remain
red until function is
UNLOCK
reset.
To reset indicator:
➢ Press and hold both the LOCK/
UNLOCK and the WATER buttons
simultaneously for 4 seconds. The
green filter status indicator light will
flash 3 times when the function
has successfully reset.
TEMPERATURE KEYS
These keys will lower or raise the freezer
or fresh food compartment temperature.
NOTE: See the section How to Adjust
the Temperature Controls (page 12) for
instructions on how to set food
compartment temperatures.
FILTER
GOOD
CHANGE
LOCK
WATER
TEMP SET