Five-Button Control Features - Kenmore 596.53462302 Use & Care Manual

Five-button control features

DISPENSER
WATER
OPERATION
To dispense:
➢ Select CUBE, CRUSH or WATER
mode by pushing button on dispenser
control panel. A green indicator light
above button shows mode selection.
➢ Press container against dispenser
pad. Selection mode may not be
changed while ice dispenser is in
operation.
NOTE: If water dispenser is
continuously active for more than 5
minutes, an automatic lock out sensor
will shut down power to dispenser area.
For instructions on how to unlock your
dispenser, see the section entitled
Dispenser Lock below.
DISPENSER LOCK
This feature prevents ice or
water from being dispensed.
To lock and unlock dispenser:
➢ To lock dispenser, press and hold
LOCK/UNLOCK button for 3
seconds. A green indicator light
above button confirms dispenser is
locked.
➢ To unlock dispenser, hold
LOCK/UNLOCK button for 3
seconds. Green indicator light above
button will go out.
LOCK
GOOD
WATER
CHANGE
UNLOCK
FILTER
DISPENSER
FILTER STATUS
CRUSH CUBE
INDICATOR LIGHT
The filter status indicator light
serves as a reminder to
replace the water filter. A green light
indicates that the filter is in good
condition. A red light indicates the filter
should be changed. Once light turns red,
it will remain red until function is reset.
To reset indicator:
➢ Press and hold both LOCK/UNLOCK
and WATER buttons simultaneously
for 4 seconds. The green filter status
indicator light will flash 3 times when
the function has successfully reset.
AUTO LIGHT
The auto light function
offers the ability to activate the
dispenser light at half-power when the
LOCK
UNLOCK
LIGHT SENSOR detects that the light
levels in room are low.
To activate and deactivate auto light:
➢ To activate, press ON/OFF button
located on control panel. A green
indicator light above button displays
to show that sensor is active.
➢ To deactivate, press ON/OFF button.
Green indicator light will go out.
NOTE: Dispenser light will operate
whether or not auto light is selected.
CRUSH CUBE
ON/ OFF
LIGHT
FILTERED ICE & WATER
GOOD
CHANGE
FILTER
LIGHT
ON/ OFF
SENSOR
LIGHT
SENSOR
SABBATH
MODE
This mode is intended to deactivate
power to the LED and dispenser lights,
while allowing the controls to remain
operational.
To activate and deactivate Sabbath
Mode:
➢ To activate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneously for 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will turn off.
Dispenser light will not activate
during dispensing while in this
mode.
➢ To deactivate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneously for 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will activate.
NOTE: In the event that power is
interrupted while the Sabbath Mode is
active, the control will remain in Sabbath
Mode when power returns.
LOCK
ON/ OFF
UNLOCK
19