Ensuring Proper Air Circulation; Control Panel Features - Kenmore 795.5103 Series Use & Care Manual

ENSURING PROPER AiR CiRCULATiON
In order to ensure proper temperatures, air must flow
between
the refrigerator and freezer sections.
* Coo[ air enters the freezer through the vents located at the
top of the compartment and exits through the vents located
behind the freezer drawers.
* Cool air from the freezer section enters the fresh food
section through vents located at the top of the compartment.
The air moves down throughout the compartment and exits
through the vents located behind the crisper drawers.
* Do not block any of these vents with food packages.
If the vents are blocked, airflow wii[ be interrupted and
temperature and moisture problems may occur.
iMPORTANT:
Because air circulates
between both sections,
any odors formed in
one section wii[ transfer
to the other. You must
thoroughly dean both
sections to eliminate
odors. To prevent odor
transfer and dried out
food, wrap or cover
foods tightly. (See the
Food Storage Guide
section for details.)
NOTE: If you dose the refrigerator door, you may see the
freezer door open and dose again due to pressure from
internal air flow.
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off: dust
accumulated during shipping.
2. Install accessories such as ice cube bin, drawers, shelves,
etc., in their proper places. They are packed together to
prevent possible damage during shipment.
3. Let your refrigerator run for at least 2 or 3 hours before
putting food in it. Check the flow of cold air in the freezer
compartment to ensure proper cooling.
Your refrigerator is now ready for use.
CONTROL PANEL FEATURES
REFRIGERATOR AND FREEZER CONTROLS
It is recommended to maintain the temperature of 37°F (3°C)
in the refrigerator compartment and 0°F (-18°C) in the freezer
compartment. To adjust temperatures, press Fridge Temp
graphic and Freezer Temp graphic.
The lower the number, the colder the compartment will be.
NOTE: The refrigerator temperature can be modified from
33°F to 46°F (0°C to 8°C). The freezer temperature can be
modified from -6°F to 8°F (-21°C to -13°C).
To change temperature unit from Fahrenheit to Celsius or from
Celsius to Fahrenheit press and hold Fridge Temp and Freezer
Temp buttons.
Display Off Mode
• When the refrigerator is in the Display Off: Mode, the
dispJay wiJ[ remain off: untiJ a door is opened or a button is
pressed. Once on, the dlspiay wlil remain on for 20 seconds.
• To deactivate the DispJay Off: Mode, press and hoJd the
Freezer Temp and UJtra Ice buttons for 5 seconds untiJ the
tone sounds. Repeat this procedure to reactivate the DispJay
Off: Mode.
ICE & WATER
You can select water or ice.
* Select Water, Crushed Ice or Cubed Ice by pressing the
ICE & WATER button to the selection desired. The Water,
Crushed Ice or Cubed Ice icon will light up to indicate
selection.
Cube
Crush
Selecting this icon indicates that cubed ice wii[ be
dispensed when the dispenser pad is activated.
Selecting this icon indicates that water will be
dispensed when the dispenser pad is activated.
Selecting this icon indicates that crushed ice wii[ be
dispensed when the dispenser pad is activated.
To dispense water or ice, gently push your cup against the
dispenser pad.
NOTE: Hold your cup in place for a couple of seconds after
dispensing ice or water so the last few drops go in your cup
instead of on the floor.
16