Electronic Control Operation - Kenmore 461.95882 Use & Care Manual

ELECTRONIC CONTROL OPERATION:
1) Temperature Increase
2) Temperature Decrease
3) LED Display
4) Fahrenheit/Celsius Selector
5) Fahrenheit/Celsius Mode Indicators
The electronic LED display on this refrigerator is
programmed to display (independently)the following
temperature (only) information:
INTERNAL CABINET TEMPERATURE: This setting is
represented by a steady (non-flashing) LED display
and is the normal (LED) default setting during
operation.
SET OPERATING TEMPERATURE: This setting is
represented by a flashing LED display and can only
be programmed(SET) by pressing and releasing
either of the J, T temperature keys during operation.
Note: The set temperature can only be adjusted/set
while the LED is in "flashing" mode.
DEFAULT SETTINGS: When the unit is first connected
to the power supply (and/or in the event of a power
failure) temperature settings automatically revert to
the following default settings:
The LED default setting for the internal temperature is
the ambient (room) temperature measured at the time
the unit is connected or power is restored.
The LED default setting for the set operating
temperature is 41 °F/5°C - we recommend you set the
temperature to 37°F/2.8°C to start, then adjust if
needed. Note: After a power failure has occured, the
previously set temperature is automatically erased
and will have to be re-set).
The LED default setting for temperature selection
(°F/°C) is °F (Farenheit Scale).
SETTING OPERATING TEMPERATURE:
To set/change the operating temperature:
1) Press and release either of the A T (temperature)
keys.
The LED display will temporarily revert to the
(flashing) set temperature for approximately 5
seconds (if you fail to set/change the operating
temperature within this 5 second period, the LED will
automatically revert back and display the internal
temperature.
2) Each depression of the A key (during flashing
mode) will increase the temperature incrementally
by 1 (temperature ranges between 36°F - 46°F
(2°C _ 8°C)
:3) Each depression of the _ key (during flashing
mode) will decrease the temperature incrementally
by 1 ; temperature will display for approximately
5 seconds after the selection is made, then revert
back to display the current internal temperature.
TEMPERATURE SELECTION (°F/°C): This unit can
display temperatures in the "Fahrenheit" or "Celsius"
scales. Press the temperature selector keypad to
alternate between °F/°C scale. The blue indicator
light adjacent to the corresponding mode (the mode
indicator light) will illuminate to signify the selection
made.
DEFROSTING: Your refrigerator is designed with an
"Auto-Cycle" defrost. What is Auto-Cycle Defrost?
The refrigerated surfaces of the fresh food
compartment defrost automatically during the "off"
cycle of the thermostat. Defrost water from the fresh
food compartment is disposed of automatically by
means of being channeled onto a drip tray located on
the compressor. Heat transfer from the compressor
causes the defrost water to evaporate.
To turn "off" the refrigerator permanently, you must
disconnect the power cord from the electrical outlet.
There is no "off" position (setting) available on the
electronic control panel.
NOTE: Wait 3 to 5 minutes before restarting if
operation has been interrupted (i.e. due to power
failure).
5