Advertisement
27. Remove the center table arm cover (four clips).
Remove the center table (three nuts).
Routing the i -VES Harness and Installing the
Monitor Console
28. Using isopropyl alcohol on a shop towel,
thoroughly clean the area where the cushion tape
will attach. Attach the cushion tape to the edge of
the vehicle frame.
AUDIO UNIT
OPENING
i -VES
HARNESS
20-PIN
CONNECTOR
SRS UNIT
i -VES HARNESS
8-PIN CONNECTOR
29. Route the i -VES Harness:
Route the i -VES Harness 16-pin connector
•
(black) from the audio unit opening through the
glove box opening and along the passenger's
door to the right center pillar.
•
Route the i -VES Harness 8-pin connector
from the audio unit opening to the SRS unit.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
CENTER
TABLE
i -VES HARNESS
CUSHION
TAPE
VEHICLE
FRAME
Turn over
the floor
carpet.
i -VES
HARNESS
i -VES HARNESS
16-PIN
CONNECTOR
(Black)
30. Continue routing the i -VES harness 16-pin
connector up the center pillar.
NUT
31. Wrap the piece of wire around the i -VES harness
16-pin connector. Using electrical tape, secure the
wire to the connector so that the end of the wire
will not get caught. Pull the 16-pin connector
behind the headliner and out of the small cutout
until the harness clip comes through the cutout.
Remove the tape and the wire.
i -VES
HARNESS
16-PIN
CONNECTOR
(Black)
PIECE
OF WIRE
AII 26017 (0308)
i -VES HARNESS
16-PIN CONNECTOR
(BLACK)
i -VES
HARNESS
Route inside
the floor panel.
i -VES
HARNESS
CENTER
PILLAR
FLOOR
CARPET
ELECTRICAL
TAPE
9 of 15
Advertisement
