Advertisement
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Using scissors, cut out the marked areas of the
template along the lines.
FRONT
TEMPLATE
VENT
Strip of
masking
tape
UTILITY
KNIFE
FELT-TIP
PEN
4.
Position the template on the headliner at the two
front vents, and secure it with masking tape. Mark
the headliner as indicated on the template with a
felt-tip pen (two places).
5.
Remove the template. Using a utility knife, cut out
the marked areas of the headliner. Remove and
discard the cut pieces of the headliner and the
insulation.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
Cut out the
marked area
from the
headliner.
FRONT
VENT
TEMPLATE
Cut out the area.
6.
Remove the center panel:
•
Move the gear selector to the D1 position.
•
Using a small flat-tip screwdriver wrapped with
a shop towel, gently pry out and remove the
plastic cover.
•
Reach inside the cover hole, and gently pull
along the bottom to release the lower clips;
then work toward the top to release all 10 clips.
•
Pull out the console panel, unplug the
connectors, and remove the panel.
Without Navigation System:
SMALL
FLAT-TIP
SCREWDRIVER
WITH SHOP
TOWEL
With Navigation System:
NAVIGATION
UNIT
VEHICLE
CONNECTOR
CONSOLE
PANEL
AII 26017 (0308)
VEHICLE
CONNECTOR
CLIPS (10)
TABS (10)
CONSOLE
PANEL
PLASTIC
COVER
VEHICLE
CONNECTOR
CLIPS (10)
TABS (10)
3 of 15
Advertisement
