2 • Product Description
The NETernity CP921RC‐30X Switches are 24‐port managed L2/L3 Gigabit
Ethernet switches, which provide cost‐effective, high‐speed network connectivity
in both standard and industrial grade construction. All ports are fully managed
solutions and comply with PICMG 2.16 specifications.
Optionally, through the front panel, the NETernity CP921RC‐30X Switch can
provide two 10Gigabit Ethernet interfaces using Small Form‐factor Pluggable
Plus (SFP+) modules and two Gigabit Ethernet SFP ports while routing 22 Gigabit
Ethenet ports to the rear I/O.
2.1 Features
The NETernity CP921RC‐30X Switches feature the following standard and
optional components:
All NETernity CP921RC‐30X Switches are factory installed with default settings
and configuration. The NETernity CP921RC‐30X Switches (hereafter referred to as
CP921RC‐30X) are available in the models listed in Table 2‐1. Table 2‐2 lists
supported Rear Transition Modules (RTM), which are used in conjunction with
the CP921RC‐30X.
All CP921RC‐30X and RTM models are available with polyurethane conformal
coating (–CC) or acrylic conformal coating (—CCA).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
• Management Board — with Processor and EEPROM:
– 32‐bit, 66 MegaHertz (MHz) PCI interface from Processor to Switch
– Access through Serial Console Interface or remote 10/100Mbps port
• Base Switch Board — with the following, depending on the model:
– 24‐Port GbE Switch Fabric with three octal GbE PHYs
• Optional, four Ethernet ports accessible via front panel:
– Two 10GbE SFP+ ports with 10GbE PHY
– Two 1GbE SFP ports
• Front panel LEDs for link/activity status
• Hot Swap insertion and removal support per PICMG 2.1 R2.0
• IPMI Controller for PICMG 2.9‐compliant shelf management through IPMB‐
0 serial bus
• Power regulators onboard for power distribution
NOTE
For additional configurations, please contact a GE Intelligent Platforms' sales representative.
Product Description 23
.