Table of Contents
Advertisement
1.1.3 Safety Precautions
The following general safety precautions must be observed during all phases of
the operation, service, and repair of this product. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture and intended use of this product.
1.2 Required Tools
A wrist strap or anti‐static mat or device is necessary when handling the
CP921RC‐30X and components.
A small Phillips head screwdriver is required to secure two mounting screws.
1.3 Kit Contents
The CP921RC‐30X Kit contains the following components:
16 NETernity CP921RC-30X Hardware Reference Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
• Ground the System
To minimize shock hazard, the chassis and system cabinet must be
connected to an electrical ground.
Refer to the documentation that accompanies the chassis or system cabinet
for specific grounding information.
• Do Not Operate in an Explosive Atmosphere
CAUTION
Do not operate the system in the presence of flammable gases or
fumes. Operation of any electrical system in such an environment
constitutes a definite safety hazard.
• Keep Away from Live Circuits
CAUTION
Operating personnel must not remove product covers. Component
replacement and internal adjustments must be made by qualified
maintenance personnel. Do not replace components with power
cable connected. Under certain conditions, dangerous voltages may
exist even with the power cable removed. To avoid injuries, always
disconnect power and discharge circuits before touching them.
• Do Not Substitute Parts or Modify System
CAUTION
Because of the danger of introducing additional hazards, do not
install substitute parts or perform any unauthorized modification to
the product . Return the product to GE Intelligent Platforms for
service and repair to ensure that safety features are maintained.
• CP921RC‐30X
• RS‐232 Serial Cable
Advertisement
Table of Contents
