Additional Information; Changing The Digital Security Code; Installing The Beltclip; Headset Installation - Uniden EXAI378 Owner's Manual

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset
and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set.
(See "About the digital security code", page 7.) In the rare situation that you
suspect another cordless telephone is using the same security code, you can change
the code.
1) Remove the handset from the base unit. Press and hold find hs on the base.
2) While the handset is emitting the paging sound, place the handset on the base
unit holding find hs. The paging sound stops. Leave the handset on the base
for more than 3 seconds. A new random security code is set.

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on
each side of the handset. Press down
until it clicks.

Headset Installation

Your phone may be used with an optional headset, the Uniden
HS910. To use this feature, insert headset plug into the headset
jack. Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department
or visiting the web site. See Page 8.)
To remove the beltclip
Pull both sides of the beltclip to
release the tabs from the holes.
A D D I T I O N A L I N F O R M A T I O N
If the handset battery
pack is completely
discharged or the
battery pack is removed,
the digital security code
will be lost. If this
happens, a new security
code is set automatically
next time the battery
pack is charged.
[ 53 ]