Uniden EXAI378 Owner's Manual page 19

Choosing the dial mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However, some phone systems still use pulse dialing such as in rural areas.
The default setting is tone dialing. Depending on your dialing system, set the
mode as follows:
1) When the phone is in the standby mode, press and hold
cid/menu. The following screen appears.
2) Press 4 or press three times to select "
3) Press select to toggle between "
4) Press end or return the handset to the base unit to complete the setting. The
handset returns to the standby mode.
Setting the language
1) When the phone is in the standby mode, Press and hold
cid/menu. The following screen appears.
2) Press 5 or press four times to select "
3) Press select to toggle between "
4) Press end or return the handset to the base unit to complete the setting. The
handset returns to the standby mode.
".
" and " ".
".
" and " ".
• If you are not sure
of your dialing
system, make a trial
call. If the call
connects, leave the
setting as is,
otherwise set for
pulse dialing.
• If your phone system
requires pulse
dialing and you need
to send the DTMF
tones for certain
situations during a
call, you may
"switch-over" to
tone dialing (refer to
"Tone Dialing
Switch-over" on
page 20).
G E T T I N G S T A R T E D [ 17 ]