Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code. To
change the digital security code:
! If the battery pack
1) De-register all the handsets you have (see "De-register the handset" on page 28).
is completely
2) Register the handsets by following step 2-3 in "Register the handset" on page 63.
drained, the
handset will not
Find Handset
beep when
paging.
To locate the handset, press
All registered handsets beep for 60 seconds, and Paging appears on the handset display. To
cancel paging, press any key on the handset or
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the holes.
Headset Installation
Your phone can be used with an optional headset. To use this
feature, insert the headset plug
into the headset pack. Your phone is ready for hands-free
conversations. (Headset can be purchased by visiting our website;
www.uniden.com.au , www.uniden.co.nz ).
flash/find hs
on the base when the phone is in standby mode.
flash/find hs
on the base.
[67]