Display Setup; Auto Power Off; Wait To Start - Doosan 12/154 Operation & Maintenance Manual

DISPLAY SETUP

The Display Menu functions give users the ability to configure the LCD. Options for configuring the display include intensity, contrast, and viewing
mode. To access the Display Menu:
1. Press and hold the ENTER Button while the Default Screen of Engine Hours is displayed until the Main Menu appears.
2. Scroll to the Setup option using the DOWN Button and press the ENTER Button.
3. Scroll to the Display option using the DOWN Button and press the ENTER Button.
4. Use the DOWN or UP Buttons to highlight and the ENTER Button to select the desired display setting. See Figure 7.
5. To return to the Default Screen of Engine Hours, use the DOWN Button to highlight the Main Screen menu item and press the ENTER Button.
Note: Main Screen menu item returns the user back to the Default Screen of Engine Hours.

AUTO POWER OFF

The Compressor Control System has a power save feature
designed to prevent drain on the batteries when the compressor
engine is not running. If the Control Panel is powered ON and the
engine has not run for 3 minutes (above 45°F (7°C) or 15 minutes at or
below 45°F (7° C)), the control system will automatically power OFF.
Power can be restored by pressing the Main Power Button.
In the event of a fault, this feature is not active and the power will
remain on until the fault has been acknowledged or the control system
is manually powered off.
OPERATING INSTRUCTIONS
Figure 7

WAIT TO START

When the Main Power Button is pressed, the display will initialize
and the Wait to Start message will be displayed. While the Wait to Start
message is displayed, the engine will receive heat from the intake
heater if required. It is best to start the engine immediately after the
Wait to Start message changes to Engine Total Hours.
21
12/154