Table of Contents
Advertisement
MN004476A01-AE
Chapter 6: Advanced Features
Your user name, unit ID, and password must be provisioned in PremierOne
PremierOne must be linked to an ARS account specifying a token to be used with the Two-Factor
passcode.
You can upgrade the Single Factor session to a Two- Factor session by entering the Two-Factor
passcode only. After an interruption, for example mode change, Dynamic System Resilience (DSR)
switch over, or power loss, the radio is able to restore the active session in its current state as long as
the session is active in the server.
6.13.1.1
Logging in using the Two-Factor Authentication
Procedure:
1 Perform one of the following actions:
•
Press the preprogrammed User Login button.
•
or to User, and press the Menu Select button directly below User.
The display shows the User Login screen.
2 Perform one of the following actions:
•
or
to [ID Entry] and press the Menu Select button directly below Edit. A blinking
cursor appears. Use the keypad to type or edit a username. Press the Menu Select button
directly below Ok to submit.
•
or
to scroll through the list of predefined usernames. Press the Menu Select button
directly below Sel to select the predefined username.
•
Press and hold
Press the Menu Select button directly below Sel to select the predefined username.
If the selected predefined username has more than the maximum allowed characters, or an
invalid character in it, the display shows momentary Invalid ID.
3 For radio enabled with Unit ID, perform one of the following actions:
•
or
to [UnitID Entry] and press the Menu Select button directly below Edit. A
blinking cursor appears. Use the keypad to type or edit a Unit ID. Press the Menu Select
button directly below Ok to submit.
•
or
to scroll through the list of predefined Unit IDs. Press the Menu Select button
directly below Sel to select the predefined Unit ID.
•
Press and hold
Press the Menu Select button directly below Sel to select the predefined Unit ID.
If the selected predefined Unit ID has more than the maximum allowed characters, or an invalid
character in it, the display shows momentary Invalid UnitID.
4 Enter your password when you see a blinking cursor.
5 Press the Menu Select button directly below Logn or Ok.
If only one-factor is enabled, the display shows 1F logged at the status. The login operation is
complete.
If login fails, the display shows momentary Login failed. The display returns to User Login
screen.
6 For radio enabled with two-factor login, enter your passcode when you see a blinking cursor.
82
or
to scroll through the list of predefined usernames at a fast scroll rate.
or
to scroll through the list of predefined Unit IDs at a fast scroll rate.
™
. Your user account in
Advertisement
Table of Contents
