Graco Hurricane 234902 Instructions-Parts List Manual page 7

TI7536
13. On handset unit, extend the nozzle sleeve (b) by pulling it away from the dispenser. While holding sleeve in extended
position, press the trigger until fluid begins to flow.
TI7045
14. On handset unit, press trigger to dispense fluid.
Safety Check
When you turn on the Hurricane Electric Pump (step 12
in the Setup and Operation procedure), the software
checks two critical safety components. While this check
is occurring, the pump will not dispense and the meter
screen displays the current software revision (i.e., x.xx).
Do not press the trigger or the dispense button until the
meter screen displays 0.00. If you attempt to dispense
before the check is complete, you must release the trig-
ger or dispense button and press again to dispense.
Priming
If the pump does not immediately prime when turned on,
follow these steps:
311216J
b
TI7537
TI7046
15. On tapper unit, press dispense button to dispense fluid.
1. Extend the nozzle by pulling the nozzle sleeve as
indicated by the label wrapped around the nozzle.
2. While the nozzle is extended, press the trigger on
the handset to dispense fluid (air may be felt at the
nozzle outlet).
3. Continue to hold the nozzle sleeve in the extended
position, with the trigger pressed, until fluid is dis-
pensed from the nozzle outlet.
4. To avoid splashing back onto skin or into eyes,
always aim dispenser or dispense tube at inside wall
of pail.
Setup and Operation
7