Table of Contents
Advertisement
Color profile: Disabled
Composite
Default screen
IMPORTANT
You can change the
receiver volume only when
you are on a call.
TIP
If the base loses power
while the handset is off the
base, the digital code may
be erased. If this happens,
the handset won't
function. You must
reestablish the connection
between the handset
and base.
8
I:...exv958final.vp
Fri Jun 19 20:15:08 1998
ADJUSTING RINGER CONTROLS
Ringer tone and volume
With no call in progress, press
The phone has 3 ringer tones with 2
volume levels - one soft and one loud.
Each time you press
ringer
the ringer tone changes.
Each time you press
volume
the ringer volume changes.
Receiver volume
While on a call, press
volume
The phone has two receiver volume
levels - one soft and one loud.
Each time you press
volume
the receiver volume changes.
AUTOMATIC DIGITAL CODE SECURITY
To avoid unauthorized calls on your phone, a digital code
was added to the EXV 958 phone. Only the handset and base
share this digital code. The code will automatically set when
you first use the phone.
To change the digital code:
1) Place the handset on the base.
2) Press
on the base.
page
The handset will beep for about 15 seconds.
3) When the beeping stops, briefly remove the handset and
then return it to the base.
The
LED blinks to indicate that the digital security
status
code is set to one of the more than 65,000 codes.
To establish communication between the handset and base:
1) Restore power to the base.
2) Place the handset on the base. The
indicate that the digital security code is set.
.
ringer
,
,
.
,
LED blinks to
status
Advertisement
Table of Contents
