11713D Front And Rear Panels At A Glance; Figure 1-1 11713D Front Panel Features - Keysight Technologies 11713D Operating And Service Manual

11713D Front and Rear Panels at a Glance

This section briefly describes the function of the front panel keys of 11713D.
12
11
Figure 1-1
1 LCD screen
2 Softkeys: These unmarked keys are referred to by the text on display next to them.
3 Menu/Enter: Press this key to select the highlighted parameter On/Off or select the highlighted
field or go back to the main menu.
4 Preset: Press this key to preset the driver.
5 Config: Press this key to access the configuration menu. You can set the attenuator type, supply
voltage, and TTL condition through this menu.
6 Save/Recall: Press this key to save current settings or recall saved settings.
7 Navigation buttons: The arrow keys are used to navigate parameters displayed on the LCD
screen or change parameters such as GPIB address.
8 Switches: In the local mode, pushbutton switches 9 and 0 change the position of a coaxial
switch connected to rear panel banana jacks S9 A/B and S0 A/B respectively.
9 Attenuator Y: In the local mode, pushbuttons 5, 6, 7, and 8 change the attenuation setting of an
attenuator or change the position of coaxial switch(es) connected to the ATTEN Y connector on
the rear panel.
10 Attenuator X: In the local mode, pushbuttons 1, 2, 3, and 4 change the attenuation setting of
an attenuator or change the position of coaxial switch(es) connected to the ATTEN X connector
on the rear panel.
11 On/Stand by: Press this key to switch between on and standby. When power is supplied, the
background LED is red. Pressing the key once switches the driver on and the background LED
turns to green.
12 Local: Press this key to control the driver from the front panel when it is operating via the
remote interfaces.
Keysight 11713D/E Operating and Service Manual
1 2
10
9
11713D front panel features
3 4
5
6
7
8
Introduction 1
19