Front And Rear Panel Features; Figure 1-2 J7204/5/A/B Front Panel - Keysight Technologies J7204A Operating And Service Manual

1 Introduction

Front and rear panel features

This section provides an overview of the front and rear panels of the J7204/5/A/B.
Refer to the standard instrument documentation for damage limits to the
CAUTION
ports. Verify that your test setup will not cause those limits to be exceeded.
Front panel
Instrument state LEDs
Standby button
Figure 1-2
Note that this button is Standby only, not a line switch. The main power cord can be used as the system
Standby button
disconnecting device. It disconnects the mains circuits from the mains supply.
When power is applied to the J7204/5/A/B, the J7204/5/A/B enters its power-on sequence which
Instrument state requires several seconds to complete. The LEDs provide information on the state of the J7204/5/A/B
LEDs during power on and during upgrades of the J7204/5/A/B's firmware.
the J7204/5/A/B's states based on the color and functionality of the LEDs.
– For J7204A/B: There are four channels, with two ports per channel: Port 1 and Port 2. Each channel
Ports
– For J7205A/B: There are five channels, with two ports per channel: Port 1 and Port 2. Each channel
18
J7204/5/A/B front panel
has one input port and one output port. The front panel RF connector is either SMA (female) or
Type-N.
has one input port and one output port. The front panel RF connector is either SMA (female) or
Type-N.
Keysight J7204/5/A/B Operating and Service Manual
Table 1-2 on page 19 identifies