Local Operations; Getting Started With The 11713D/E - Keysight Technologies 11713D Operating And Service Manual

5

Local Operations

Getting Started with the 11713D/E

The Keysight 11713D/E attenuator/switch driver can be easily configured to drive programmable
attenuators and/or switches through the front panel operations. The following three simple steps
will guide you through the configuration of the 11713D/E.
Step 1: Turn on the 11713D/E
NOTE
1 Connect the AC power supply to the 11713D/E. You should see:
– the background LED of the power button is red which indicates that the 11713D/E is in the
2 Press the power button once to turn on the 11713D/E. You should see:
– the background LED turns green.
– six menus are displayed on the LCD screen.
– all numbered buttons are lighted up
3 Ensure the Local button is lighted up to enable operation through the front panel. If not, press
the button once.
4 Now, you are ready to configure the 11713D/E.
Step 2: Configure the 11713D/E settings to drive attenuators and switches
To drive programmable attenuators
NOTE
[1] At factory default setting. Last state is followed if instrument was configured before shutdown.
44
For Step 1, all details on the 11713E are applicable to the 11713D.
standby mode.
Step 2 — To drive programmable attenuators, only item 2 is applicable to the
11713D. When the Config button is pressed, the next screen is
CONFIGURATION MENU.
[1]
.
Keysight 11713D/E Operating and Service Manual