Huawei SmartACU2000D Quick Manual page 27

Smart array controller with no pid module

Hide thumbs Also See for SmartACU2000D:

1. Prepare a communications cable.

2. Connect the communications cable to the

JX01 terminal block.

3. Crimp an OT terminal on the shield layer,

and then connect the shield layer to the

cabinet ground point.

4. Bind the communications cable.

6.9

(Optional) Connecting the Peripheral Network Cable

Connect peripheral network cables to ports FE2–FE5 on the Ethernet switch. All network cables

are connected in the same way. This section describes how to connect one network cable.

1. Prepare a network cable.

2. Verify that the network cable functions

properly using a network cable tester.

3. Connect the peripheral network cable to

the FE2 port on the Ethernet switch.

4. Bind the network cable.

(1) White-

(2) Orange (3) White-and-

and-

orange

(5) White-

(6) Green (7) White-and-

and-blue

(4) Blue

green

(8) Brown

brown

Table of Contents