Huawei SmartACU2000D Quick Manual page 25

5. Connect one end of the optical
jumper to the fiber adapter.
6. Route the other end of the
optical jumper through the
cable hole on the side of the
ATB, and then connect the
cable to the ATB.
7. Connect the peripheral optical
cable to the ATB, splice the
optical cable and the optical
jumper, and then wind the
spliced cable around the fiber
spool on the ATB.
8. Check that the cables are
connected correctly and
securely. Then reinstall the
optical cable fastener and ATB
cover.
6.6 Connecting the 4G LTE Cable
1. Connect the factory-installed network cable to
the DATA port on the PoE module, and the
factory-installed power cable to the PoE module.
6.7 Connecting the Three-Phase AC Power Cable
•
For the smart array controller that supports the access of one MBUS route, connect the three-
phase AC power cable to the FU01 switch.
•
For the smart array controller that supports the access of two MBUS routes, connect the first
route to the FU01 switch, and the second route to the FU02 switch.
•
This section describes how to connect the three-phase AC power cable for the smart array
controller that supports the access of two MBUS routes. For details about the single-route
situation, refer to the way of connecting the first route of the three-phase AC power cable.
1. Prepare a cable.
2. Connect the CPE network cable to the PoE
port on the PoE module.
24