Download Print this page

Maintenance - Adam Equipment MDW-250L Manual

Digital physician scale
Hide thumbs Also See for MDW-250L:

Advertisement

• Further, if the middle tube is pulled out straight, it is possible
to measure the height from 126-190 cm. The reading can be
obtained at the conjoint place where the upper part of outside
tube screw meets with the middle tube scale.

7.0 MAINTENANCE

• Do not dismantle the weighing machine without following the
necessary instructions.
• Do not jump while standing on the load-bearing board. This
may damage the sensor inside.
• Do not move the weighing machine violently and abruptly. It is
recommended to move and put down the weighing machine
gently.
• It is suggested to wipe the stains with soft cloth soaked with
detergent and to wipe later with soft cloth too. Do not use
organic solutions and boiled water to wipe the stains. Do not
use water for cleaning.
• Keep the weighing machine in a dry and clean environment. Do
not expose it outdoor or use it in locations near fire, under
direct sunshine or with high temperature.
• When lifting the height meter, it is suggested to pull it straight
along the pipe without using excessive force.
• The [On/Off] key on the screen board only switches off the
screen power instead of the entire power to the weighing
machine. Therefore, it is necessary to switch off the main
power supply when the weighing machine is not in use for a
long time. Otherwise the battery may be damaged as a result of
over-discharge.
© Adam Equipment Company 2006
5

Advertisement

loading

This manual is also suitable for:

Mdw-250 l