Related Manuals for Adam Equipment MDW-250L
Summary of Contents for Adam Equipment MDW-250L
- Page 1 Adam Equipment MDW-250L DIGITAL PHYSICIAN SCALE (P.N. 4302, Rev. B4, January 2006) © Adam Equipment Company 2006...
- Page 2 372 X 272 mm Overall dimension 535 X 275 X 940 mm Deadweight 13 kg Environment for Use Temperature: 5ºC-40ºC; Humidity: <85℅ RH Power AC 220V through an adapter Battery Internal, re-chargeable 6V, 5 hours approx. © Adam Equipment Company 2006...
- Page 3 The arrow indicator will point at kg, lb, Hold, Tare, Stab or/and Zero marked below the LCD panel, as on when they are chosen. When the adapter is connected to recharge the battery, it will show a red indicator. © Adam Equipment Company 2006...
- Page 4 • Press the [On/Off] key to switch off the scale. If the scale is not to be used for a long time, the main power switch should be turned off to save the battery life. • To start weighing, press [On/Off], the scale will show “0.0”. © Adam Equipment Company 2006...
- Page 5 • When the tube is pulled out straight, it is sufficient to measure the height from 80 to 126 cm. The number can be obtained upon the conjoint place where the upper part of middle tube screw meets with the inside tube scale. © Adam Equipment Company 2006...
- Page 6 Therefore, it is necessary to switch off the main power supply when the weighing machine is not in use for a long time. Otherwise the battery may be damaged as a result of over-discharge. © Adam Equipment Company 2006...
- Page 7 Shielded interconnect cables must be employed with this equipment to insure compliance with the pertinent RF emission limits governing this device. Changes or modifications not expressly approved by Adam Equipment could void the user's authority to operate the equipment. © Adam Equipment Company 2006...
- Page 8 © Copyright by Adam Equipment Co. Ltd. All rights reserved. No part of this publication may be reprinted or translated in any form or by any means without the prior permission of Adam Equipment. Adam Equipment reserves the right to make changes to the technology, features, specifications and design of the equipment without notice.
Need help?
Do you have a question about the MDW-250L and is the answer not in the manual?
Questions and answers