Table of Contents
Advertisement
8. While the mast is in the horizontal position,
unpin the horizontal lock pin from the
mast.
9. Pull out on the spring-loaded pin to the
unlocked
position
underside of the mast).
10. Once lock pins are removed, slide the mast
out to the desired height and replace the
horizontal lock pin.
NOTE: The spring-loaded pin must be in the
"locked" position when sliding out the mast
to keep mast from sliding completely out of
channel
11. Ensure the hand-pump knob is in the "UP"
position and raise the mast to full height.
Take note of overhead obstacles as well as
required working distances. Follow any
lock out/ tag out procedures required by
your organization. Steps need to be taken
to ensure that the unit will not be lowered
while workers are attached to the unit
which could lead to serious injury or death.
NOTE: Be sure to allow for adequate swing fall
distances
12. Re-install the lock pin to the lower mast.
13. Use the attached tagline to lower each SRL connector for use. Once attached the system
is ready for use. Follow all directions while using the XSERIES Mobile Grabber
14. To dismantle the unit, follow all steps above in reverse order
XSERIES Instruction Manual
MaltaDynamics.com | 800-494-1840
(Located
on
the
12
Advertisement
Table of Contents
