Assembly Preparation; Assembly Instructions; Remove Components From The Box; Securing Front Legs To The Grill - Pit Boss Lockhart Platinum PB2180LK Instructions And Recipes Manual

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. REMOVING COMPONENTS FROM THE BOX
Parts Required:
Main Grill/Hopper Assembly (#3)
1 x
Installation:
• Open the color box.
• Remove all components from the smoker and firebox.
• Place a piece of foam board on the floor to prevent scratching the unit.
• Lay the Main Grill/Hopper Assembly on it's right side to the foam board.

2. SECURING FRONT LEGS TO THE GRILL

Parts Required:
1 x Front Left Leg (#15)
1 x Front Right Leg (#18)
Main Grill/Hopper Assembly (#3)
1 x
Screw (#A)
6 x
6 x Washer (#D)
6 x Locking Washer (#E)
Installation:
• Open the lid of firebox.
• Mount Front Left Leg and Front Right Leg to the bottom of the Grill/
Hopper Assembly.
Use: 6 pcs screws, 6 pcs washer, and 6 pcs locking washer.
NOTE: Fasten screws of the support legs only half-way to allow easier
installation in next step.
8

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1
2
D A
E