Installing The Grill Lid Handle; Installing The Hopper Lid Handle; Mounting Flame Broiler Components - Pit Boss Lockhart Platinum PB2180LK Instructions And Recipes Manual

20. INSTALLING THE ASH TRAY
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
1 x Ash Tray (#10)
1 x Ash Tray Bracket (#9)
Installation:
• Insert Ash Tray to the Ash Tray Bracket.

21. INSTALLING THE GRILL LID HANDLE

Parts Required:
1 x Main Grill/Hopper Assembly (#3)
1 x Lid Handle Assembly (#7)
Installation:
• Remove the two pre-installed screws from Lid Handle Assembly,
mount the Lid Handle Assembly onto the Lid of Grill/Hopper Assembly.

22. INSTALLING THE HOPPER LID HANDLE

Parts Required:
1 x Main Grill/Hopper Assembly (#3)
1 x Hopper Lid Handle Assembly (#8)
Installation:
• Remove the two pre-installed screws from Hopper Lid Handle Assembly,
mount the Hopper Lid Handle Assembly onto the Lid of Hopper.
23. INSTALLING THE FLAME BROILER COMPONENTS
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
Flame Broiler Main Plate (#26)
1 x
Flame Broiler Slider (#27)
1 x
Installation:
• Place the flame broiler slider on top of the flame broiler main plate, with
the raised tab on the right side. Ensure the two tabs on the slider
place into the slot holes of the main plate, covering the slotted openings.
Note illustration 23A.
• Insert the flame broiler main plate into the main grill. Rest the flame broiler
main plate on the built-in ledge (on the inside right) of the main
grill that directs grease towards the grease bucket spout. Slide the entire
piece to the left side, and the two slots on the flame broiler main plate
will fit into the rounded ledge above the burn pot. It will sit slightly at a
downward angle. Note illustration 23B.
• Both flame broiler parts are lightly coated with oil to avoid rusting
when shipped.
IMPORTANT: If the main plate is resting on the base of the barrel,
it is installed incorrectly. Poor installation may result in damage to your
main grill barrel.
20
21
22
23A
23B
13