Konica Minolta Bizhub 4000i User Manual page 201

Error Message
Size Error DX
Size Mismatch
Toner Low
Too Many Trays
bizhub 5000i
Error Message
2-sided Disabled
Access Denied
Cartridge Error
Cooling Down
Cover is Open
Cover is Open
Cause
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
The paper in the tray is not the
correct size.
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
The number of installed Optional
Trays exceeds the maximum
number.
Cause
The back cover of the machine is
not closed completely.
The 2-sided tray is not installed
completely.
The function you want to use is
restricted by Secure Function
Lock 3.0.
The toner cartridge is not installed
correctly.
The temperature of the inside of
the machine is too hot. The
machine will pause its current print
job and go into cooling down
mode.
The front cover is not completely
closed.
The fuser cover is not completely
closed.
Action
Press Cancel (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper sizes available for automatic 2-sided
printing are Letter, Legal, Mexico Legal, India
Legal and Folio.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Go.
Order a new toner cartridge now so you have
it ready when the LCD displays Replace
Toner.
Reduce the number of Optional Trays.
Action
Close the back cover of the machine until it
locks in the closed position.
Install the 2-sided tray firmly in the machine.
Call your administrator to check your Secure
Function Lock Settings.
Remove the toner cartridge and imaging unit
assembly. Take out the toner cartridge, and put
it back in the imaging unit again. Reinstall the
toner cartridge and imaging unit assembly in
the machine.
If the problem continues, contact customer
support.
Make sure you can hear the fan in the
machine spinning and that the exhaust outlet
is not blocked.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use it
for several minutes.
If the fan is not spinning, disconnect the
machine from the power for several minutes,
then reconnect it.
Open and then firmly close the front cover of
the machine.
Close the fuser cover located inside the back
cover of the machine.
197