Table of Contents
Advertisement
13. To install the CD changer (cars without an on-board monitor only)
X18180
X18126
A
A2
A
X13016
A3
A
Retrofit / Installation kit No. 65 12 137 916 (others see cover sheet)
Installation Instructions No. 01 29 137 925
A
046 0214 B
A1
046 0215 B
X322
046 0216 B
046 0209 B
Issue date: 10.2001
0
The installation of the power supply cable A
is only required if the black 3-pin socket
casing X18180 on the connection cable for
the CD changer is not tied back near the
CD changer installation location on the audio
wiring harness.
Open the black 17-pin socket casing X18126 and
0
disconnect the existing socket contact from slot
PIN7, white/red/yellow cable.
Connect branch A1, 1-pin socket contact, white/
red/yellow cable on the power supply cable A to
the black 17-pin socket casing X18126 in slot
PIN7.
Connect the supplied black 1-pin socket
casing (9) to the disconnected socket contact
9
and connect this to branch A1, black 1-pin plug
casing, white/red/yellow cable.
Open the black 8-pin socket casing X322 and
0
disconnect the existing socket contact from slot
PIN4 , red/green cable.
Connect branch A2 , 1-pin socket contact, red/
green cable on the power supply cable A to the
black 8-pin socket casing X322 in slot PIN4.
Connect the supplied black 1-pin socket casing (9)
to the disconnected socket contact and connect
this to branch A2, black 1-pin plug casing, red/
green cable.
9
Lay the power supply cable A along the audio wiring
harness to the installation location of the CD
changer and secure it with cable ties.
0
The figure shows the installation space in the
left side wall in the passenger
compartment.
Connect branch A3, earth eyelet 6 mm, brown
cable, on the power supply cable A to the earth
post X13016 behind the audio module holder.
Lay branch A4, black 3-pin socket casing, to the
installation location of the CD changer.
EN/22
Advertisement
Table of Contents
