Table of Contents
Advertisement
4.
Connection diagram for the power supply cable A
(for cars with an on-board monitor radio only)
This power supply cable A is only required for cars with an on-board monitor radio.
0
Power supply cable A is only required if the black 3-pin socket casing on the CD changer power
supply is not tied back on the audio wiring harness on the left-hand side of the boot.
Item
A
Power supply cable
A1
Black 1-pin plug casing, socket
contact I bus
A2
Black 1-pin plug casing, socket
contact terminal 30
A3
Cable eyelet 6 mm
A4
3-pin black socket casing
Retrofit / Installation kit No. 65 12 137 916 (others see cover sheet)
Installation Instructions No. 01 29 137 925
A1
Description
Issue date: 10.2001
A2
Cable
colour
---
white/red/
Connect to the audio wiring harness 100 mm before the
yellow
17-pin or 16-pin socket casing on the on-board monitor
radio using a 2-way insulation-piercing connector (6) to
white/red/yellow cable
red/green
Connect to the audio wiring harness 100 mm before the
17-pin or 16-pin socket casing on the on-board monitor
radio using a 5-way insulation-piercing connector (7) to
red/green cable
brown
Earth post X13016 behind the audio module holder
---
Power supply connection X18180 on CD changer (1)
A3
A
500mm
Connection location in the car
---
A4
046 0201 B
EN/7
Advertisement
Table of Contents
