To Install The Acm Unit And Universal Can Interface For E87 Cars - BMW 1 Series Installation Instructions Manual

12. To install the ACM unit and universal CAN interface for E87 cars

F
1
1
2
1
A15
A16
F
D
A1
© BMW AG, Munich
F
C
087 0731 Z
C
A15
087 0789 Z
2
C
087 0734 Z
087 0753 Z
01 29 0 420 167
Use cable tie F to attach ACM unit C to the heating
2
duct (1) behind the glove compartment.
The deployment of the airbag (2) must not be
!
impaired by ACM unit C.
For cars with M-ASK only
Use the coding (1) on the plugs to connect them
correctly.
Connect plugs to ACM unit C as shown:
- Plug (2) on the existing signal cable (white 10-pin)
- Branch A15 (blue 18-pin plug)
B1
- Branch B1 (violet 10-pin plug)
Cars with CCC only
Remove coding (1) from plug (2) on the existing signal
cable (blue 10-pin).
Connect plugs to ACM unit C as shown:
- Plug (2) on the existing signal cable (blue 10-pin)
- Branch A15 (blue 18-pin plug)
- Branch B1 (violet 10-pin plug)
B1
All cars
In countries in which image reproduction is
permitted up to a particular speed, the red cable
from PIN 2 must be disconnected at branch A1, insulated
and tied back.
Use cable ties F to attach universal CAN interface D to
the standard wiring harness.
Connect branch A1 to the universal CAN interface D.
Tie back any excess cable to the standard wiring harness.
Tie back branch A16.
8/2006 (Z/Z) 20