Table of Contents
Advertisement
3 1/2 2A Mini Digital Clamp Meter user manual
SAFETY WARNING
Read the operating instructions before using the
1.
instrument and pay particular attention to all WARNINGS
and CAUTIONS in this instruction manual.
Be sure that the cover and the test leads of the meter are
2.
in good conditions.
Set the range / function switch at the correct position when
3.
measuring.
Make sure to insert the red and the black test leads to their
4.
appropriate jacks. The black test lead should be connected
first when measuring while the red test lead should be
disconnected first after measuring.
When the range and function changes, both test leads
5.
should be disconnected.
To avoid damage to the instrument, never exceed the
6.
allowable maximum input of each range.
Be care of electric shock hazard when the voltage to be
7.
tested is above DC 60V or AC 30V.
To avoid electric shock, do not open the battery
8.
compartment cover when making measurement.
Remove the test leads from the circuit being measured
9.
before replacing the battery.
10. Do not change the built-in circuit to avoid damage to the
meter.
11. Do not use or store the instrument in an explosive
atmosphere (i.e. the presence of flammable gas or fume,
vapor or dust）
12. CAT II-Measurement Category II is for measurements
performed on circuits directly connected to low voltage
installation.（Examples are measurements on household
appliances, portable tools and similar equipments.） Dot not
use the meter for measurements within Measurement
Categories III and IV
13.
2
Advertisement
Table of Contents
