Table of Contents
Advertisement
3 1/2 2A Mini Digital Clamp Meter user manual
range position.
2)
Press the trigger to open jaw. Fully enclose only one
conductor.
3)
Take the reading on the LCD.
MEASURING RESISTANCE
Beware of Electrocution.
Ensure that the test leads are disconnected from the
meter before making current clamp measurements.
1)
Plug the black test lead into the COM jack and the red test
lead into the V/Ω Jack.
Set the rotary selector to Ω/
2)
the meter get into AC V range.
3)
Connect the test leads to the ends of the resistance or
circuit for measurement.
4)
Take the reading on the LCD.
TESTING CONTINUITY
Beware of Electrocution.
Make sure that the power of the circuit has been
turned off and the capacitors have been fully
discharged before testing the continuity of a circuit.
1)
Plug the black test lead into the COM jack and the red test
lead into the V/Ω Jack.
Set the rotary selector to Ω/
2)
Press the "SEL" button to switch to
3)
4)
Connect the test leads to the ends of the resistance or
circuit for measurement.
If the resistance of the circuit being tested is less than 50Ω,
5)
the built-in buzzer will sound.
6)
Take the reading on the LCD.
TESTING DIODE
1)
Plug the black test lead into the COM jack and the red test
WARNING
/ range position to make
WARNING
/
9
range position.
continuity test.
Advertisement
Table of Contents
