Avaya S8700 Maintenance Manual page 2105

SN-CONF (Switch Node Configuration)
Table 8-565. TEST #760 Processor Route Audit Test — Continued
Error Test
Code Result Description / Recommendation
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL If this test fails, one or more administered circuit packs in this switch node
carrier did not respond with a "board insertion" uplink message. Verify that
administered SNI and SNC boards match the physically installed SNI and SNC
boards by entering list config carrier UUC. The command output will show
"NO BOARD" for every board that is administered, but not inserted.
PASS If this test passes, every administered circuit pack in this switch node carrier
was inserted.
555-233-143
If every administered board is inserted, run this test again.
If administration does not match the physical configuration, and is
correct, insert the missing circuit packs in this switch node carrier.
If administration does not match the physical configuration, and is
incorrect, change the administration, and run this test again.
If none of the administered boards in this switch node carrier were
inserted, fix any other SN-CONF errors by following the associated
repair procedures for SN- CONF. Use display errors with
category pnc to view SN-CONF errors. Next check if any INLs,
LNLs, or RNLs are down with list sys-link. If any INLs, LNLs, or
RNLs are down, see
''SYS-LINK (System Links)''
problems.
for fixing link
Continued on next page
Issue 1 May 2002 8-1383