Roborock S6 Pure User Manual page 25

Routine maintenance
Side brush
*Monthly Side cleaning brush recommended
1. Turn the robot over and remove the screw holding the
side brush.
2. Remove and clean the side brush.
3. Reinstall the side brush and tighten the screw.
Note:
Side brush replacement every 3-6 months is recommended to maintain cleaning
quality.
Mop cloth
*Clean after use
1. Remove the mop cloth from the mopping module.
2. Clean and dry the mop cloth.
Note:
• Always remove the mop cloth after cleaning to filter blockage.
• If the mop cloth gets excessively dirty, the cleaning quality will be affected. Always
use clean cloth.
• Replacing the mop cloth every 3-6 months is recommended to maintain cleaning
quality
Filter Assembly
*Replacement every 1-3 months recommended
1. Move your finger along the notch to remove both filters.
2. Install the new filters.
Note:
Changing filters every 1-3 months is recommended, depending on the quality of
water and frequency of use, to ensure cleaning quality.
Omnidirectional wheel
*Clean as required
1. Turn the robot over.
2. Use a small screwdriver to pry out the axle and remove
the wheel.
3. Rinse the axle and the wheel with water to remove any
hair and dirt.
4. Dry and reinstall the wheel, then press it back in place.
21