Advertisement
Quick Links
Advertisement
Related Manuals for Roborock S6 Pure
Summary of Contents for Roborock S6 Pure
- Page 1 Roborock Vacuum Cleaner S6 Pure...
-
Page 2: Part1 App Connection
Part1 App Connection https://drive.google.com/open?id=1zuui9MLG63FB5Qb8tWaNvyjKS_GZg7h... - Page 3 Part2 App Features Instruction Before the first cleaning task, please go to Settings page and turn on the map saving mode. During cleaning, please ensure that the cleaner starts from the dock charger. The cleaner will automatically return to dock charger after all the rooms have been cleaned. The charging dock needs to be placed against the wall.
- Page 4 1.Room cleaning The cleaner will automatically divide areas based on rooms. When you don't want to clean all rooms but just one or multiple rooms, go to the map interface, as shown below, and tap to select the room(s) you want to clean. At the same time, you can customize the clean mode...
- Page 5 2. Zone cleaning Only a simple one-step operation on the app is required to make the cleaner automatically clean the target area. Method: Go to the map interface and tap the Zone button. The initial areas will automatically pop up on the map. You can manually move or scale up or scale down the target cleaning area.
- Page 6 3. Edit room The complexity of the home environment may cause some errors in the automatic area division by the machine. The manual area division function allows us to correct the errors according to the actual home environment. Method: Enter the map interface for the cleaner and tap ①“Edit map”, then go to “②Edit room".
- Page 7 4. Custom cleaning mode Method：Enter the map interface, go to“Mode settings”to choose the cleaning mode.
- Page 8 5. Invisible wall and no-go zone Method: Enter the map interface for the cleaner and tap Edit map”-“No-go zone” ,Then tap the Invisible wall”\“No-go zone”,buttons to scale up/scale down/move invisible walls and no-go zones. Tap “①”save and the cleaner will not enter these zones. 注意: 1.
- Page 9 6.Carpet mode When this mode is enabled, the cleaner will automatically identify a carpet during cleaning and apply the maximum suction power to clean it, and resume its normal suction power when stepping off the carpet. Method: enter ①Setting-②Vacuum settings, Enable ③"Carpet mode" button.
- Page 10 7.DND mode This mode is enabled in the factory and effective between 22:00-08:00 by default. Note: 1.After the DND mode is enabled, if the cleaner automatically return to charging dock due to low battery capacity, the machine will not continue cleaning after the battery capacity is sufficient.
- Page 11 8. Scheduled cleaning You can set up to 10 scheduled cleaning tasks a day. After the setting is completed, if the WIFI is disconnected, the previously set timing cleaning will be invalid.（ We could choose enable scheduled cleaning for specific rooms) Note: You can manually select the cleaning mode...
- Page 12 9.Pin n Go Only a simple operation on the app is required to make the cleaner automatically move to the targeted area. Spot cleaning: After pin n go is set and the cleaner reaches the targeted point, the cleaner will start spot cleaning when you tap the spot cleaning button.
- Page 13 10. OTA upgrade Over-the-Air upgrade is supported to provide easy and convenient operation. Note: Ensure that the vacuum cleaner is charging during upgrading and the power of vacuum cleaner is higher than...
- Page 14 Thank you！...
Need help?
Do you have a question about the S6 Pure and is the answer not in the manual?
Questions and answers