Login/Logout; To Login; To Logout - NEC DT930 Series User Manual

1.
F
6. EATURE
This chapter describes how to login/logout, how to input
characters and how to make a call/hold, etc.

Login/Logout

To Login

When login mode is activated, the terminal prompts for
Login ID and Password. When the terminal starts up
with displaying the below screen, the Login Mode is
activated.
(1) The terminal starts up with the login mode.
(2) Enter Login ID.
For initial setting, enter the extension number
as Login ID.
A maximum of 16 characters can be entered
for Login ID.
After entering Login ID, press Soft key Set.
❍
O
PERATION
(3) Enter a password.
(4) If the Login ID and Password are accepted,
display changes to normal idle status.
The terminal becomes available.

To Logout

The terminal, which is operated with Login Mode, can
log out. Perform the following to logout.
107
For initial setting, enter the extension number
as password.
Four to 10 characters can be entered for
password displayed in "*".
After entering password, press Soft key OK.
❍
■
If you enter the wrong ID and/or password,
the normal screen is not displayed and will
return to the [Login] screen.
■
If this occurs, enter the correct "Login ID"
and "Password".