Advanced Menu - ResMed AutoSet CS 2 Clinician Manual

After resetting the factory defaults check if you need to reset the mask setting and redo
N
OTE
the Air Circuit Learn function. Resetting the factory defaults will not erase stored data.
E
RASE DATA
The ERASE DATA option allows you to erase all compliance data, ie data relating to
the results of a patient's session in the Results menu. It will not erase other data, eg
settings. Select the ERASE DATA option before starting therapy on a new patient to
ensure the integrity of new patient data.
To erase data, press the Left key on the ERASE DATA screen. A message will ask you
to confirm that you wish to erase data. If you are sure, press the Left key again. A
confirmation message is displayed for 3 seconds, then the next menu item is displayed.
CAUTION
!
If you select the ERASE DATA function while a SmartMedia
R L
ES INK
along with the compliance data in the flow generator. The R
attached to the A
been selected to ensure that the data on the SmartMedia card has been correctly
erased. See the ResLink Clinician's Guide for further information on managing data via
the R
D
ATE AND
The Time and Date settings cannot be altered during therapy, or backwards to a time
prior to the end of the last therapy session.
A
DVANCED
The default settings for maximum (MAX PS) and minimum (MIN PS) pressure support
will suit most patients. However, the clinician can adjust the upper limits for MAX PS
and MIN PS in the Advanced menu.
14
™ (see page 19), any compliance data on the SmartMedia card will be erased
S
UTO ET
L
and SmartMedia card.
ES INK
T
IME
M
ENU
SETTINGS
enter exit
ALARMS
enter exit
RESULTS
enter exit
OPTIONS
enter exit
ADVANCED
enter exit
SERVICING
enter exit
CS2 for 60 seconds after the ERASE DATA function has
MIN PS: 3.0 cmH2O
change
MAX PS: 10 cmH2O
change
card is in the
™
L
ES INK
exit
exit
must remain