Choose ESC protocol..........................7 Voltage and current parameters setting.....................8 Setting up the receiver..........................9 VTX serial port use. VTX uses OSD smart audio................10 Check receiver signal..........................11 Select flight mode startup mode......................12 OSD settings..............................13 LED settings..............................14 Troubleshooting............................15 ..................Package IncIuded HGLRC Zeus35 FC*1 www.hglrc.com...
3.Check the flight control drive 1. Long Press BOOT buttons.connect USB.The system automatically install the driver 2.Driver cannot be installed, please download ImpulseRC_Driver_Fixer 3.Double-click on the run(Plug in the flight controller to automatically install the driver) 4.open betaflight configurator enter DFU mode , www.hglrc.com...
Page 6
5.Click Select firmware version Load firmware Waiting for 6.Click completion It will be prompted upon completion 7.open betaflight configurator computer. Betaflight Automatically assigned port click “Connect” Enter Controller plugged into the setup interface Different computer , ( ) www.hglrc.com...
5.URAT serial port use 1.URAT1 uses VTX image transmission 2.URAT2 uses Receiver (SBUS/iBUS/DSM/CRSF/R9MM) 6.Select aircraft model Select model Click I understand the risks Click Click Push Master to check motor “ ” steering Master Steering can be changed at BLHeliSuite “ ” www.hglrc.com...
7.Choose ESC protocol 1.Choose the right ESC protocol, the optional universal protocol DSHOT600. 8.Voltage and current parameters setting 1.Click Setting parameters www.hglrc.com...
10.VTX serial port use. VTX uses OSD smart audio 1.VTX connection diagram www.hglrc.com...
Page 13
SmartAudio (TBS Unify) or “VTX TR” if you are using IRC Tramp Telemetry. To adjust PIDs, rates, and other tuning-related parameters, enter the “Profile” sub-menu. In the “Scr Layout” sub-menu, you can move the OSD elements (like battery voltage, mAh, and so forth) around on www.hglrc.com...
After making the changes, move the cursor to “Set” and press roll-right to confirm the settings. 11.Check receiver signal Check the remote control output signal Click www.hglrc.com...
12.Select flight mode startup mode Click 13.OSD settings the OSD Settings, according to the need to choose, drag Click the OSD schematic diagram of the parameters can be adjusted. www.hglrc.com...
2. If the product is damaged due to improper operation, the repair service may be provided under the condition that the inspection can be repaired. 3. For domestic customers, please contact the after-sales service personnel. For overseas customers, please contact the official website for after-sales service. www.hglrc.com...
Page 18
"BBB" sound. There is only one sound. Please check if the ESC agreement is correct 3.The spin of the aircraft keeps spinning 1. Please check if the propeller is correct 2. Please check if the motor direction is correct www.hglrc.com...