U-Line H-86 Manual page 2

1. Insert standing tube into pedal base and connect with short screw.
(See Figure 1)
2. With four long screws, connect body to standing tube. (See Figure 2)
3. Attach tension rod to puller located under base. Attach to foot
pedal. (See Figure 3)
4. Connect working plate fixed bracket to body. Attach operating
board to bracket using two short screws. (See Figure 4)
NOTE: When attaching working plate bracket, leave enough
space between body and top of screws so operating board
can be attached easily.
PAGE 2 OF 12
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Figure 3
Figure 4
0620 IH-86